1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55474C
2.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55475A
3.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55910R
4.REMOVE HEATER CONTROL ASSEMBLY
33504F
5.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
58804A
6.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
58987A
7.REMOVE NO. 2 CONSOLE BOX RETAINER
55406B
8.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
84752
9.REMOVE REFRESHING SEAT SWITCH
Detach the 4 claws to remove the refreshing seat switch.