Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › from 2013.08
RM1440E _59 Vehicle Exterior _056168 DOOR / HATCH _0274177 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  REMOVAL  


PROCEDURE

Hide 52119A 1.REMOVE FRONT BUMPER COVER (w/o TOYOTA Parking Assist-sensor System)

Hide 52119A 2.REMOVE FRONT BUMPER COVER (w/ TOYOTA Parking Assist-sensor System)

Hide 86510 3.REMOVE HIGH PITCHED HORN ASSEMBLY

Hide 53115B 4.REMOVE RADIATOR GRILLE BRACKET

Hide 86520 5.REMOVE LOW PITCHED HORN ASSEMBLY

Hide 53629 6.REMOVE HOOD LOCK CONTROL CABLE COVER

a.
B353474

Remove the 2 bolts.


b.

Detach the claw to remove the hood lock control cable cover.


Hide 53510 7.REMOVE HOOD LOCK ASSEMBLY

a.
B237114

Remove the 3 bolts.


b.
B237115

Detach the clamp.


c.

w/ Engine Hood Courtesy Switch:

Disconnect the connector.


d.

w/o Engine Hood Courtesy Switch:

Disconnect the connector cap.


e.

Disconnect the hood lock control cable and remove the hood lock assembly.


Hide 67920 8.REMOVE DOOR SCUFF PLATE ASSEMBLY LH

Hide 53601 10.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B237118

Detach the clamp.


b.
B237117

Detach the 3 claws.


c.

Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.


Hide 53630 11.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Using a screwdriver, disconnect the 3 clamps as shown in the illustration.

B353475E02
1.052,0.813 1.219,0.521 1.219,0.521 1.396,0.521 true 0.99,0.552 0.854,0.552 false 2.188,0.667 2.063,0.771 2.063,0.771 2.063,0.865 false 1.615,1.177 1.885,1.417 1.885,1.417 2.292,1.146 false 2.771,0.51 2.719,0.51 2.719,0.51 2.625,0.698 false 6.094,0.979 5.938,0.615 5.938,0.615 5.813,0.615 false 5.917,1.188 5.792,1.063 5.792,1.063 5.688,1.063 false 6.375,2.344 6.229,2.094 6.229,2.094 6.125,2.094 false 6.281,2.656 6.156,2.531 6.156,2.531 6.052,2.531 false 1.594,2.354 1.448,2.115 1.448,2.115 1.344,2.115 true 1.438,0.479 1.594,0.646 0.156,0.167 10 false *2 1.99,0.885 2.146,1.052 0.156,0.167 10 false *2 1.813,0.083 1.969,0.25 0.156,0.167 10 false *a 1.813,1.427 1.969,1.594 0.156,0.167 10 false *4 0.698,0.479 0.854,0.646 0.156,0.167 10 false *1 2.802,0.427 2.958,0.594 0.156,0.167 10 false *1 5.656,0.552 5.813,0.719 0.156,0.167 10 false *1 5.531,1 5.688,1.167 0.156,0.167 10 false *3 5.969,2.031 6.125,2.198 0.156,0.167 10 false *1 5.885,2.458 6.042,2.625 0.156,0.167 10 false *3 1.198,2.042 1.354,2.208 0.156,0.167 10 false *1

Text in Illustration
*1 Hood Lock Control Cable Assembly *2 Stopper
*3 Wire Harness *4 Grommet
*a Engine Room Side - -

HINT:

Tape the screwdriver tip before use.



b.

Pull the hood lock control cable assembly from the engine compartment to remove it.