85330F
1.INSTALL REAR WASHER MOTOR AND PUMP ASSEMBLY
Install the rear washer motor and pump to the packing of the washer jar.
85330
2.INSTALL WASHER JAR
85301
3.INSTALL WASHER INLET SUB-ASSEMBLY
4. FILL WASHER FLUID
53875A
5.INSTALL FRONT FENDER LINER RH
Install the fender liner (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA>INSTALLATION).
52119A
6.INSTALL FRONT BUMPER COVER
except X-Runner:
Install the front bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>INSTALLATION).
for X-Runner:
Install the front bumper cover (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for X-Runner)>INSTALLATION).
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
8.ADJUST FOG LIGHT AIMING
Adjust the fog light aiming (See page Vehicle Exterior>LIGHTING (EXT)>FOG LIGHT ASSEMBLY>ADJUSTMENT).