Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > Security Indicator Light Circuit

for Preparation Click here


DESCRIPTION

  1. When the engine immobiliser system is set, the security indicator light blinks continuously, but does not illuminate if the engine immobiliser system is not set.

WIRING DIAGRAM


B353562E02


INSPECTION PROCEDURE

NOTICE:
When the transponder key ECU assembly is replaced, refer to Registration (Click here).

1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY INDICATOR)
  1. Check that the security indicator light illuminates when operating it with the Active Test (Click here).

    Immobiliser 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator light
    ON/OFF
    The test is possible when the following conditions are met:
    1. The key is in the ignition key cylinder.

    OK:
    Security indicator light can be turned on and off using the Techstream.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT SECURITY INDICATOR LIGHT (TELLTALE LIGHT ASSEMBLY)
  1. Remove the security indicator light (telltale light assembly) (Click here).

  1. Inspect the security indicator light (telltale light assembly) (Click here).



NG
REPLACE SECURITY INDICATOR LIGHT (TELLTALE LIGHT ASSEMBLY) (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (TELLTALE LIGHT - TRANSPONDER KEY ECU AND BODY GROUND)
  1. Disconnect the F32 security indicator light (telltale light assembly) connector.

  1. Disconnect the F34 transponder key ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F32-6 (LP) - F34-8 (IND)
    Always
    Below 1 Ω
    F32-1 (GND) - Body ground
    Always
    Below 1 Ω
    F32-6 (LP) or F34-8 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)