DTC C1401 Front Speed Sensor RH Malfunction |
DTC C1271 Low Output Signal of Front Speed Sensor RH (Test Mode DTC) |
DTC C1272 Low Output Signal of Front Speed Sensor LH (Test Mode DTC) |
DTC C1402 Front Speed Sensor LH Malfunction |

| DTC Code | DTC Detection Condition | Trouble Area |
| C1401 C1402 | One of the following conditions is met:
|
|
| C1271 C1272 | Stored only during test mode. |
|
| 1.CHECK FRONT SPEED SENSOR INSTALLATION |
Turn the ignition switch off.
![]() |
Check the speed sensor installation.
| *1 | Front Speed Sensor |
| *a | No clearance |
| *b | OK |
| *c | NG |
|
| ||||
| OK | |
| 2.INSPECT FRONT SPEED SENSOR TIP |
Remove the front speed sensor (Click here).
Check the speed sensor tip.
|
| ||||
| OK | |
| 3.INSPECT FRONT SPEED SENSOR ROTOR |
Remove the front axle with ABS rotor bearing assembly (for 2WD: Click here, for 4WD: Click here).
Check the speed sensor rotor.
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (FRONT SPEED SENSOR) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Start the engine.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Wheel Speed | Front wheel speed sensor RH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Actual wheel speed | No large fluctuations when driving at a constant speed. |
| FL Wheel Speed | Front wheel speed sensor LH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Actual wheel speed | No large fluctuations when driving at a constant speed. |
Check that there is no difference between the speed value output from the speed sensor displayed on the Techstream and the speed value displayed on the speedometer when driving the vehicle.
|
| ||||
| OK | ||
| ||
| 5.REPLACE FRONT SPEED SENSOR |
Replace the front speed sensor (Click here).
| NEXT | |
| 6.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTCs C1401 and C1402 are not output | A |
| DTCs C1401 and/or C1402 are output (for 2WD) | B |
| DTCs C1401 and/or C1402 are output (for 4WD) | C |
|
| ||||
|
| ||||
| A | ||
| ||