FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD) > INSTALLATION |
| 1. INSTALL FRONT DIFFERENTIAL CARRIER ASSEMBLY |
Install the front No. 3 differential support with the 2 bolts.
Install the front No. 2 differential support with the 2 bolts.
Install the front No. 1 differential support with the 3 bolts.
Support the front differential with a jack.
Install the 2 front mounting bolts and 2 nuts.
for w/A.D.D. :
Connect the actuator hose and connector.
Install the No. 1 front differential mounting nut.
Install the front differential breather tube bracket with the bolt.
Lower the jack.
| 2. INSTALL FRONT PROPELLER SHAFT ASSEMBLY |
Install front propeller shaft assembly (Click here).
| 3. INSTALL FRONT DRIVE SHAFT ASSEMBLY |
Install the front drive shaft assembly (Click here).
| 4. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH |
Install the front lower No. 1 suspension arm sub-assembly (Click here).
| 5. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH |
| 6. CONNECT TIE ROD END SUB-ASSEMBLY LH |
Connect the tie rod end sub-assembly LH .
| 7. CONNECT TIE ROD END SUB-ASSEMBLY RH |
Connect the tie rod end sub-assembly RH .
| 8. INSTALL FRONT SPEED SENSOR |
Install the front speed sensor (Click here).
| 9. INSTALL FRONT WHEEL |
| 10. ADD DIFFERENTIAL OIL |
Remove the differential filler plug and gasket.
![]() |
Pour oil into the rear differential carrier assembly so that the oil level is within 0 to 5 mm (0 to 0.197 in.) of the bottom of the filler plug opening.
| Differential Type | Oil Type and Viscosity | Specified Condition |
| Standard | Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent | 1.35 to 1.45 liters (1.43 to 1.53 US qts, 1.18 to 1.27 Imp. qts.) |
| w/ A.D.D. (Automatic Disconnecting Differential) | 1.50 to 1.60 liters (1.59 to 1.69 US qts, 1.32 to 1.40 Imp. qts.) |
| Differential Type | Oil Type and Viscosity | Specified Condition |
| Standard | Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent | 2.65 to 2.75 liters (2.80 to 2.91 US qts, 2.33 to 2.42 Imp. qts.) |
| w/ Differential Lock | Toyota Genuine Differential gear oil LT 75W-85 GL-5 or equivalent | 2.60 to 2.70 liters (2.75 to 2.85 US qts, 2.29 to 2.38 Imp. qts.) |
Install a new gasket and the differential filler plug.
Drive the vehicle and check the oil level again.
If necessary, add differential oil.
| 11. INSPECT DIFFERENTIAL OIL LEVEL |
Stop the vehicle on a level surface.
Remove the differential filler plug and gasket.
![]() |
Check that the oil level is within 0 to 5 mm (0 to 0.197 in.) of the bottom of the filler plug opening.
Install a new gasket and differential filler plug.
| 12. CHECK FOR DIFFERENTIAL OIL LEAKAGE |
| 13. INSTALL REAR ENGINE UNDER COVER ASSEMBLY |
Install the rear engine under cover assembly with the 4 bolts.
| 14. INSTALL NO. 1 ENGINE UNDER COVER |
![]() |
Hook the No. 1 engine under cover sub-assembly to the vehicle body as shown in the illustration.
Install the 4 bolts.
| 15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 16. CHECK SPEED SENSOR SIGNAL |
Check the VSC sensor signal .
| 17. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
Inspect and adjust the front wheel alignment (Click here).