Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


DESCRIPTION

When the ignition switch is turned to ON, the center airbag sensor transmits front seat inner belt LH state signals to the combination meter through the CAN. If the driver side seat belt is not fastened, the combination meter blinks the driver side seat belt warning light. If the seat belt is fastened, the warning light goes off.

WIRING DIAGRAM


C213668E01


INSPECTION PROCEDURE

NOTICE:
The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure (Click here).

1.CHECK FOR DTC (AIRBAG SYSTEM)
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    Airbag system DTC is output
    B



B
GO TO AIRBAG SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER SIDE SEAT BELT WARNING LIGHT)
  1. Operate the Techstream according to the display and select Active Test (Click here).

    Combination Meter 
    Item
    Test Part
    Control Range
    Diagnostic Note
    Driver Side Seat Belt
    Driver side seat belt warning light
    ON/OFF
    Confirm that the vehicle is stopped and the engine is idling.

    OK:
    Driver side seat belt warning light condition can be switched by Active Test.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


3.REPLACE CENTER AIRBAG SENSOR ASSEMBLY
  1. Temporarily replace the center airbag sensor with a new one (Click here).


NEXT


4.CHECK DRIVER SIDE SEAT BELT WARNING LIGHT
  1. Check the driver side seat belt warning light function (Click here).

    OK:
    Driver side seat belt warning light operates normally.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

END (CENTER AIRBAG SENSOR IS DEFECTIVE)