SMART KEY SYSTEM (for Entry Function) > Back Door Entry Lock and Unlock Functions do not Operate |

| 1.CHECK POWER DOOR LOCK OPERATION |
When the door control switch on the multiplex network master switch assembly is operated, check that the doors unlock and lock according to the switch operation (Click here).
|
| ||||
| OK | |
| 2.CHECK WAVE ENVIRONMENT |
Bring the electrical key transmitter approximately 0.3 m (0.984 ft.) from the electrical key antenna (outside luggage) and perform an entry back door unlock function check (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK ELECTRICAL KEY ANTENNA IN KEY DIAGNOSTIC MODE |
Check the following antenna in the key diagnostic mode (Click here).
Check the electrical key antenna (outside luggage).
When the electrical key transmitter is brought within 0.7 to 1.0 m (2.30 to 3.28 ft.) of the electrical key antenna (outside luggage), check that the wireless door lock buzzer sounds.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (ELECTRICAL KEY ANTENNA - CERTIFICATION ECU) |
Disconnect the N21 antenna connector.
Disconnect the F78 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N21-1 (CLG5) - F78-19 (CLG8) | Always | Below 1 Ω |
| N21-2 (CLGB) - F78-20 (CG8B) | Always | Below 1 Ω |
| F78-19 (CLG8) - Body ground | Always | 10 kΩ or higher |
| F78-20 (CG8B) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.INSPECT ELECTRICAL KEY ANTENNA (OUTSIDE LUGGAGE) |
![]() |
Remove the electrical key antenna (outside luggage) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (CLG5) - 2 (CLGB) | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||