Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL LEVEL WARNING SWITCH ASSEMBLY
  1. Install the level warning switch assembly to the packing of the washer jar.



2. INSTALL WASHER JAR PROTECTOR
  1. Attach the 3 claws to install the washer jar protector.



3. INSTALL WASHER JAR


    E198972E01
  1. Attach the guide to install the washer jar, and then install the 3 screws.

    HINT:
    Tighten the screws in the order shown in the illustration.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



4. INSTALL WASHER INLET SUB-ASSEMBLY
  1. Install the clip to the washer inlet sub-assembly.



5. FILL WINDSHIELD WASHER FLUID
  1. Connect the washer hose to the hose of the windshield washer motor and pump assembly and fill the washer jar with windshield washer fluid.



6. INSTALL FRONT FENDER LINER RH
(Click here)


7. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


8. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



10. ADJUST FOG LIGHT AIMING
(Click here)