Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Rear Side)

WASHER MOTOR (for Rear Side) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(Click here)


3. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(Click here)


4. REMOVE FRONT FENDER LINER RH
(Click here)


5. DRAIN WINDSHIELD WASHER FLUID


    E198963
  1. Disconnect the washer hose from the hose of the windshield washer motor and pump assembly and drain the windshield washer fluid.



6. REMOVE WASHER INLET SUB-ASSEMBLY


    E198964
  1. Detach the clip and remove the washer inlet sub-assembly.



7. REMOVE WASHER JAR


    E198971
  1. Disconnect the connector.



    E198972
  1. Remove the 3 screws.



    E198973
  1. Detach the guide to remove the washer jar.



8. REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY


    E197546E01
  1. Remove the rear washer motor and pump assembly from the packing of the washer jar.
    Text in Illustration 
    *1
    Packing