DTC B27A5 Open in Front Floor Electrical Key Oscillator Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B27A5 | An open circuit is detected in the circuit between the certification ECU and indoor No. 1 electrical key antenna (front floor) (CLG5 - CLG3, CG5B - CLGB). |
|

| 1.CHECK CONNECTOR CONNECTION |
Turn the engine switch off.
Check that the connectors are properly connected to the certification ECU and indoor No. 1 electrical key antenna (front floor).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (INDOOR NO. 1 ELECTRICAL KEY ANTENNA - CERTIFICATION ECU) |
Disconnect the F77 antenna connector.
Disconnect the F79 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F77-1 (CLG3) - F79-7 (CLG5) | Always | Below 1 Ω |
| F77-3 (CLGB) - F79-8 (CG5B) | Always | Below 1 Ω |
| F79-7 (CLG5) - Body ground | Always | 10 kΩ or higher |
| F79-8 (CG5B) - Body ground | Always | 10 kΩ or higher |
| F79-15 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK CERTIFICATION ECU |
Measure the voltage according to the value(s) in the table below.

| *a | Component with harness connected (Certification ECU) | - | - |
| Tester Connection | Switch Condition | Specified Condition |
| F79-7 (CLG5) - F79-15 (E) | Engine switch off, all doors closed, key not in cabin and lock sensor off → on | No pulse generation → Pulse generation |
| F79-8 (CG5B) - F79-15 (E) | Engine switch off, all doors closed, key not in cabin and lock sensor off → on | No pulse generation → Pulse generation |
|
| ||||
| OK | |
| 4.REPLACE INDOOR NO. 1 ELECTRICAL KEY ANTENNA ASSEMBLY (FRONT FLOOR) |
Temporarily replace the indoor No. 1 electrical key antenna (front floor) with a new or normally functioning one (Click here).
| NEXT | |
| 5.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||