DTC B27A6 Open in Rear Floor Electrical Key Oscillator Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| B27A6 | An open circuit is detected in the circuit between the certification ECU and indoor No. 2 electrical key antenna (rear floor) (CLG6 - CLG4, CG6B - CLGB). |
|

| 1.CHECK CONNECTOR CONNECTION |
Turn the engine switch off.
Check that the connectors are properly connected to the certification ECU and indoor No. 2 electrical key antenna (rear floor).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (INDOOR NO. 2 ELECTRICAL KEY ANTENNA - CERTIFICATION ECU) |
Disconnect the O9 antenna connector.
Disconnect the F79 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O9-1 (CLG4) - F79-24 (CLG6) | Always | Below 1 Ω |
| O9-3 (CLGB) - F79-25 (CG6B) | Always | Below 1 Ω |
| F79-24 (CLG6) - Body ground | Always | 10 kΩ or higher |
| F79-25 (CG6B) - Body ground | Always | 10 kΩ or higher |
| F79-15 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK CERTIFICATION ECU |
Measure the voltage according to the value(s) in the table below.

| *a | Component with harness connected (Certification ECU) | - | - |
| Tester Connection | Switch Condition | Specified Condition |
| F79-24 (CLG6) - F79-15 (E) | Engine switch off, all doors closed, key not in cabin and lock sensor off → on | No pulse generation → Pulse generation |
| F79-25 (CG6B) - F79-15 (E) | Engine switch off, all doors closed, key not in cabin and lock sensor off → on | No pulse generation → Pulse generation |
|
| ||||
| OK | |
| 4.REPLACE INDOOR NO. 2 ELECTRICAL KEY ANTENNA ASSEMBLY (REAR FLOOR) |
Temporarily replace the indoor No. 2 electrical key antenna (rear floor) with a new or normally functioning one (Click here).
| NEXT | |
| 5.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||