Home › Drivetrain ยท AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL STEERING KNUCKLE LH
  1. Install the steering knuckle LH with the 2 bolts and 2 new nuts.

    Torque:
    155 N*m{ 1581 kgf*cm , 114 ft.*lbf }



2. INSTALL FRONT LOWER SUSPENSION ARM ASSEMBLY LH
  1. Install the nut and the front lower suspension arm assembly LH.

    Torque:
    51 N*m{ 520 kgf*cm , 38 ft.*lbf }

  1. Install new cotter pin.



3. INSTALL TIE ROD SUB-ASSEMBLY LH
  1. Install the nut and the tie rod sub-assembly LH to the steering knuckle LH.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }

  1. Install a new cotter pin.

    NOTICE:
    If the holes for the clip are not aligned, tighten the nut up to an additional 60°



4. INSTALL FRONT DISC BRAKE DUST COVER LH
  1. Install the 3 bolts and the front disc brake dust cover LH to the steering knuckle LH.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



5. INSTALL FRONT WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



6. INSTALL FRONT AXLE HUB SUB-ASSEMBLY
(Click here)


7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)


8. VSC SENSOR NEUTRAL MEMORIZATION
(Click here)


9. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)
(Click here)


10. ADJUST HEADLIGHT AIMING (w/ HID Headlight System)
(Click here)