DTC P0088 Fuel Rail / System Pressure - Too High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0088 | Fuel pressure is higher than the target value for 10 seconds or more. (1 trip detection logic) |
|
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0088) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0088 is output | A |
| DTC P0088 and other DTCs are output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING GTS |
Connect the GTS to the DLC3.
Start the engine and turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure / Fuel Press.
Check that the fuel pressure fluctuates when the target fuel pressure changes.
|
| ||||
| OK | |
| 3.REPLACE FUEL PUMP ASSEMBLY (FOR HIGH PRESSURE) |
Replace the fuel pump assembly (for high pressure) (Click here).
| NEXT | |
| 4.CHECK IF DTC OUTPUT RECURS (SEE IF DTC P0088 IS OUTPUT AGAIN) |
Connect the GTS to the DLC3.
Turn the GTS on.
Clear the DTCs (Click here).
Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0088 is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||