DTC P0985 Shift Solenoid "E" Control Circuit Low (Shift Solenoid Valve SR) |
DTC P0986 Shift Solenoid "E" Control Circuit High (Shift Solenoid Valve SR) |
| DTC No. | DTC Detection Condition
| Trouble Area |
| P0985 |
|
|
| P0986 |
|
|

| TCM command gearshift | 1st | 2nd | 3rd | 4th | 5th | 6th |
| Shift solenoid valve SR | ON | ON | ON | ON | OFF | OFF |
| 1.INSPECT TRANSMISSION WIRE (SR) |
Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A18-15(SR) - Body ground | Ignition switch ON | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A18-15(SR) - Body ground | 20°C(68°F) | 11 to 15 Ω |
Connect the TCM connector.
|
| ||||
| OK | |
| 2.REPLACE TCM |
Replace the TCM (Click here).
| NEXT | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - TCM) |
Disconnect the A18 TCM connector.
Disconnect the L4 transmission wire connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L4-3(SR) - Body ground | Ignition switch ON | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L4-3(SR) - A18-15(SR) | Always | Below 1 Ω |
| L4-3(SR) and A18-15(SR) - Body ground | Always | 10 kΩ or higher |
Connect the A18 TCM connector.
Connect the L4 transmission wire connector.
|
| ||||
| OK | |
| 4.INSPECT SHIFT SOLENOID VALVE SR |
Remove the shift solenoid valve SR (Click here).
Perform inspection of the shift solenoid valve SR .
|
| ||||
| OK | ||
| ||