DTC No.
| DTC Detection Condition
- Diagnosis Condition
- Malfunction Status
- Malfunction Time
- Other
| Trouble Area
|
P0751
| - While driving with the shift lever in D, the ATF temperature 20°C (68°F) or more, and coolant temperature 40°C (104°F) or more. (However, abnormalities with the shift solenoid valve S1, S2, S3, S4, SR, SL1, SL2, SLT), input speed sensor NT, output speed sensor SP2, park/neutral position switch, CAN bus, ECM communication, coolant temperature sensor, air flow sensor, electronically control throttle, and accelerator pedal sensor are not detected)
- The following conditions are met:
- When the TCM commands shifting to 5th, the actual gear position is also switched to 5th.
- When the TCM commands shifting to 6th gear, the engine overruns (in neutral)
- -
- 2-trip detection logic
| - Shift solenoid valve S1
- Harness or connector
- Transmission wire
- TCM
|
P0752
| - While driving with the shift lever in D, the ATF temperature 20°C (68°F) or more, and coolant temperature 40°C (104°F) or more. (However, abnormalities with the shift solenoid valve S1, S2, S3, S4, SR, SL1, SL2, SLT), input speed sensor NT, output speed sensor SP2, park/neutral position switch, CAN bus, ECM communication, coolant temperature sensor, air flow sensor, electronically control throttle, and accelerator pedal sensor are not detected)
- The following conditions are met:
- - During driving with the shaft lever in D, when the TCM commands shifting to 1st gear, the actual gear position is shifted to 2nd.
- - When the TCM commands shifting to 5th gear, the actual gear position is also shifted to 5th
- -
- 2-trip detection logic
| - Shift solenoid valve S1
- Harness or connector
- Transmission wire
- TCM
|