DTC C146C Open in ABS Motor Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C146C | Any of the following is detected:
|
|

| 1.PERFORM ACTIVE TEST USING GTS (ABS MOTOR RELAY) |
Connect the GTS to the DLC3.
Start the engine.
Select the Active Test using the GTS (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | ABS motor relay | Relay ON/OFF | Operating sound of motor can be heard |
Check the operating sound of the pump motor when operating it using the GTS.
| Result | Proceed to |
| Operating sound is heard. | A |
| Operating sound is not heard. | B |
|
| ||||
| A | |
| 2.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for 30 seconds or more.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C146C is not output. | A |
| DTC C146C is output. | B |
|
| ||||
| A | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (+BM TERMINAL) |
![]() |
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A5-1 (+BM) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A5-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
|
| ||||
| OK | ||
| ||