DTC P0420 Catalyst System Efficiency Below Threshold (Bank 1) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0420 | Diagnostic value is more than the standard value. (2 trip detection logic) |
|

| *1 | TWC: Front Catalyst | *2 | TWC: Rear Catalyst |
| *3 | Exhaust Manifold | *4 | Air Fuel Ratio Sensor |
| *5 | Heated Oxygen Sensor | *6 | Front Exhaust Pipe Sub-Assembly |
| *7 | Front Exhaust Pipe Assembly | *8 | Center Exhaust Pipe Assembly |
| *9 | Tail Exhaust pipe Assembly | - | - |



| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|


| 1.CHECK ANY OTHER DTCS OUTPUT |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0420 is output | A |
| DTC P0420 and other DTCs are output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING GTS (Control the Injection Volume) |
Connect the GTS to the DLC3.
Start the engine and warm it up.
Turn the GTS on.
Run the engine at an engine speed of 2500 rpm for approximately 90 seconds.
Enter the following menus: Powertrain / Engine / Active Test / Control the Injection Volume
Perform the Active Test operation with the engine idling (press the RIGHT or LEFT button to change the fuel injection volume).
Monitor the voltage outputs of the air fuel ratio sensor and heated oxygen sensor (AFS Voltage B1S1 and O2S B1S2) displayed on the GTS.
| GTS Display (Sensor) | Injection Volume | Status | Voltage |
| AFS Voltage B1S1 (Air fuel ratio) | +12.5% | Rich | Below 2.0 V |
| -12.5% | Lean | Higher than 2.4 V | |
| O2S B1S2 (Heated oxygen) | +12.5% | Rich | Higher than 0.55 V |
| -12.5% | Lean | Below 0.4 V |
| Status AFS Voltage B1S1 | Status O2S B1S2 | A/F Condition and A/F and HO2 Sensor Conditions | Misfire | Main Suspected Trouble Areas | Proceed to |
| Lean/Rich | Lean/Rich | Normal | - |
| A |
| Lean | Lean/Rich | Air fuel ratio sensor malfunction | - |
| B |
| Rich | Lean/Rich | Air fuel ratio sensor malfunction | - |
| |
| Lean/Rich | Lean | Heated oxygen sensor malfunction | - |
| C |
| Lean/Rich | Rich | Heated oxygen sensor malfunction | - |
| |
| Lean | Lean | Actual air-fuel ratio lean | May occur |
| D |
| Rich | Rich | Actual air-fuel ratio lean | - |
|
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.CHECK FOR EXHAUST GAS LEAK |
Check for exhaust gas leaks.
|
| ||||
| OK | |
| 4.REPLACE EXHAUST MANIFOLD (TWC: FRONT CATALYST) |
Replace the exhaust manifold (TWC: front catalyst) (Click here).
| NEXT | ||
| ||
| 5.CHECK FOR EXHAUST GAS LEAK |
Check for exhaust gas leaks.
|
| ||||
| OK | ||
| ||
| 6.CHECK FOR EXHAUST GAS LEAK |
Check for exhaust gas leaks.
|
| ||||
| OK | ||
| ||