Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (for RHD)

BRAKE BOOSTER (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.



    C105620E05
  1. Set the push rod length as shown in the illustration.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Brake Master Cylinder Push Rod Clevis
    *a
    Push Rod Length

    Push rod length:
    155.2 mm (6.11 in.)

  1. Tighten the lock nut.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }



2. INSTALL BRAKE BOOSTER ASSEMBLY
  1. Install the brake booster assembly to the vehicle body with the 4 nuts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Do not kink or damage the brake lines.



3. INSTALL PUSH ROD PIN


    C264102E01
  1. Apply lithium soap base glycol grease to the push rod pin.
    Text in Illustration 
    *1
    Push Rod Pin
    V100145
    Lithium Soap Base Glycol Grease

  1. Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip as shown in the illustration.

    NOTICE:
    After installation, check that the pedal operates smoothly.



4. REMOVE AND INSTALL TCM (for Automatic Transmission)
(Click here)


5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY (w/ Knee Airbag)
(Click here)


6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
  1. Connect each connector.



    B312545E01
  1. for Automatic Air Conditioning System for RHD:

    1. Connect the connector.

    2. Engage the guide and connect the aspirator hose.
      Text in Illustration 
      *1
      Aspirator Hose

  1. Engage the 4 claws.

  1. Engage the 4 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the 2 screws.



7. INSTALL INSTRUMENT SIDE PANEL RH (w/o Knee Airbag)
  1. Engage the 4 clips and claw to install the instrument side panel RH.



8. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
(Click here)


9. INSPECT AND ADJUST BRAKE PEDAL
(Click here)