Home › Suspension › REAR SUSPENSION › REAR UPPER ARM

REAR UPPER ARM > INSTALLATION

for Preparation Click here



1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH
  1. Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the 2 bolts and 2 new nuts.

    NOTICE:
    1. Insert the bolt from the rear side of the vehicle for the front side of the installation position.
    2. Insert the bolt from the front side of the vehicle for the rear side of the installation position.

  1. Temporarily install the rear upper control arm assembly LH to the axle carrier with the new bolt and a new nut.

    NOTICE:
    Insert the bolt from the front side of the vehicle.



2. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



3. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY
(Click here)


4. STABILIZE SUSPENSION


    C261010E01
  1. Jack up the axle carrier, with a wooden block placed between the jack and axle carrier, to apply load to the suspension so that the rear drive shaft assembly becomes level.
    Text in Illustration 
    *a
    Wooden Block



5. FULLY TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH
  1. Fully tighten the nut on the axle carrier side of the upper control arm assembly LH.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

  1. Fully tighten the 2 nuts on the suspension member side of the upper control arm assembly LH.

    Torque:
    90 N*m{ 918 kgf*cm , 66 ft.*lbf }



6. FULLY TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(Click here)


8. VSC SENSOR NEUTRAL MEMORIZATION
(Click here)


9. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)
(Click here)


10. ADJUST HEADLIGHT AIMING (w/ HID Headlight System)
(Click here)