1.INSPECT BRAKE LINE PIPES AND HOSES
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
Using a mirror, check the entire circumference and length of the brake lines and hoses for:
Damage
Wear
Deformation
Cracks
Bends
Corrosion
Leaks
Twists
Check all the clamps for tightness and connections for leakage.
Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
Check that the lines are installed properly and pass through the center of the grommets.
2.INSPECT BRAKE PEDAL
Check the brake pedal (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(except LHD M/T)>ADJUSTMENT except LHD M/T, See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for LHD M/T)>ADJUSTMENT for LHD M/T).
3.INSPECT PARKING BRAKE
Check the parking brake shoe clearance and parking brake lever travel (See page Brake>PARKING BRAKE>PARKING BRAKE SYSTEM>ADJUSTMENT).
Check the parking brake cables to ensure that they are not deformed or binding.
4.INSPECT BRAKE LININGS AND DRUMS
Check the parking brake linings and drums.
5.INSPECT FRONT BRAKE
Check the front brake pads and discs (See page Brake>BRAKE (FRONT)>FRONT BRAKE (for Floating Type Caliper)>INSPECTION).
6.INSPECT REAR BRAKE
Check the rear brake pads and discs (See page Brake>BRAKE (REAR)>REAR BRAKE (for Floating Type Caliper)>INSPECTION).
7.INSPECT OR CHANGE BRAKE FLUID
Inspect or change the brake fluid (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>REPLACEMENT).