Home › Engine / Hybrid System › FA20 (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL
RM2090E _51 Engine / Hybrid System _060666 FA20 ENGINE MECHANICAL _0297494 REAR CRANKSHAFT OIL SEAL A

FA20 ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 35000 1.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Hide 30300 2.REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

Hide 32101 3.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

a.
A276036E01
0.474,1.668 0.744,1.839 0.270,0.171 10 SST 1.397,1.662 0.768,1.752 false

Using SST, hold the crankshaft.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A276896

Remove the 8 bolts, drive plate and ring gear sub-assembly and rear drive plate spacer.


Hide 31210 4.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

Hide 31250 5.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 13405 6.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

a.
A276036E01
0.474,1.668 0.744,1.839 0.270,0.171 10 SST 1.397,1.662 0.768,1.752 false

Using SST, hold the crankshaft.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A276046

Remove the 8 bolts and flywheel sub-assembly.


Hide 19315 7.REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE

a.

Remove the No. 1 crankshaft position sensor plate.


Hide 11401L 8.REMOVE REAR ENGINE OIL SEAL

a.
A276048E01
0.638,1.968 0.821,2.121 0.183,0.153 10 *a 1.332,1.039 1.515,1.192 0.183,0.153 10 *1 0.662,1.433 0.724,1.952 false 1.857,1.312 1.518,1.133 false

Using a knife, cut through the oil seal lip.

Text in Illustration
*1 Protective Tape
*a Cut position


b.

Using a screwdriver with its tip taped, pry out the rear engine oil seal.

NOTICE:

After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.


HINT:

Tape the screwdriver tip before use.