Home › Engine / Hybrid System › FA20 (LUBRICATION) › LUBRICATION SYSTEM
RM2090E _51 Engine / Hybrid System _060671 FA20 LUBRICATION _0297531 LUBRICATION SYSTEM G

FA20 LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloring or thinning.

If the quality is visibly poor, replace the oil and oil filter element.


Hide 2.CHECK ENGINE OIL LEVEL

a.

Park the vehicle in a level place.


b.

With the engine turned off, check that the engine oil level is between the full level and low level marks.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not add engine oil above the full level mark.


HINT:
·

Check the oil level before the engine is started, or 5 minutes or more after the engine has been stopped (after engine warming).

·

Check both sides of the dipstick and use the value obtained from the lower side oil level.




Hide 3.CHECK OIL PRESSURE

a.

Remove the oil pressure switch assembly (See page Engine / Hybrid System>FA20 (LUBRICATION)>OIL PRESSURE SWITCH>REMOVAL).


b.
A276043

Install the oil pressure gauge with adapter.


c.

d.

Warm up the engine.


e.

Check the oil pressure under the following conditions.

Specification Oil Pressure:
Item Engine Oil Temperature Oil Pressure
Idle 80°C (176°F) 50 kPa (0.5 kgf/cm2, 7.3 psi) or more
6000 rpm 500 kPa (5.1 kgf/cm2, 73 psi) or more



f.

Remove the air cleaner assembly (See page Engine / Hybrid System>FA20 (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL).


g.

Remove the oil pressure gauge with adapter.


h.

Install the oil pressure switch assembly (See page Engine / Hybrid System>FA20 (LUBRICATION)>OIL PRESSURE SWITCH>INSTALLATION).


i.

Inspect for engine oil leaks.