Home › Drivetrain › TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM
RM2090E _52 Drivetrain _060674 TX6A AUTOMATIC TRANSMISSION / TRANSAXLE _0297556 AUTOMATIC TRANSMISSION SYSTEM C

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  P0982  Shift Solenoid "D" Control Circuit Low (Shift Solenoid Valve S4)  P0983  Shift Solenoid "D" Control Circuit High (Shift Solenoid Valve S4)  


DESCRIPTION

Based upon a signal from the TCM, the combination of shift solenoid valve (S1, S2, S3, S4, SR, SL1, SL2) changes the gear position from 1st to 6th. As a fail-safe function if the solenoid valve system is open or shorted, the TCM cuts power to all solenoids, leaving just the mechanical hydraulic circuit, requiring manual shifting.

DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P0982
1.

Not learning control prohibited status

2.

During shift solenoid valve S4 on signal is output, the TCM's S4 output monitor value is "off".

3.

Continues for 500ms or more.

4.

1-trip detection logic


·

Shift solenoid valve S4

·

Transmission wire

·

Harness and connector

·

TCM


P0983
1.

Not learning control prohibited status

2.

During shift solenoid valve S4 off signal is output, the TCM's S4 output monitor value is "on".

3.

Continues for 500ms or more.

4.

1-trip detection logic


·

Shift solenoid valve S4

·

Transmission wire

·

Harness and connector

·

TCM



MONITOR DESCRIPTION

These DTCs indicate an open or short in the shift solenoid valve S4 circuit. When there is an open or short circuit in any shift solenoid valve circuit, the TCM detects the problem and illuminates the MIL and stores the DTC.

WIRING DIAGRAM

C368964E12
1,1.594 2.5,1.781 1.5,0.188 10 false Shift Solenoid Valve S4 0.698,2.771 2.198,2.958 1.5,0.188 10 false Transmission Wire 0.708,2.615 0.885,2.781 0.177,0.167 10 false L4 2.531,0.729 3.604,1.313 1.073,0.583 10 false S4 2.771,0.729 3.271,1.125 0.5,0.396 10 false 14 5.479,0.75 5.656,0.917 0.177,0.167 10 false 14 5.708,0.948 6.271,1.448 0.563,0.5 10 false S4 5.979,2.938 6.25,3.135 0.271,0.198 10 false A18 5.969,3.094 6.313,3.302 0.344,0.208 10 false TCM

CAUTION / NOTICE / HINT

NOTICE:

Perform the universal trip to clear permanent DTCs (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR).


HINT:
·

The shift solenoid valve S4 is turned on/off normally when the shift lever is in the D position:

TCM command gearshift 1st 2nd 3rd 4th 5th 6th
Shift solenoid valve S4 OFF ON OFF OFF ON ON



PROCEDURE

1.INSPECT TRANSMISSION WIRE (S4)
a.

Disconnect the A18 TCM connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard voltage:
Tester Connection Condition Specified Condition
A18-14(S4) - Body ground Ignition switch ON Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
A18-14(S4) - Body ground 20°C(68°F) 11 to 15 Ω



d.

Connect the A18 TCM connector.



OK

2.REPLACE TCM

NG

3.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - TCM)
3.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - TCM)
a.

Disconnect the A18 TCM connector.


b.

Disconnect the L4 transmission wire connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard voltage:
Tester Connection Condition Specified Condition
L4-14(S4) - Body ground Ignition switch ON Below 1 V



d.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
L4-14(S4) - A18-14(S4) Always Below 1 Ω
L4-14(S4) and A18-14(S4) - Body ground Always 10 kΩ or higher



e.

Connect the A18 TCM connector.


f.

Connect the L4 transmission wire connector.



OK

4.INSPECT SHIFT SOLENOID VALVE S4

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT SHIFT SOLENOID VALVE S4

b.

Perform inspection of the shift solenoid valve S4 (See page Drivetrain>TX6A (AUTOMATIC TRANSMISSION / TRANSAXLE)>VALVE BODY ASSEMBLY>INSPECTION).



OK

NG