41651A
1.INSTALL REAR NO. 2 DIFFERENTIAL MOUNT CUSHION
Put matchmarks on the rear suspension member and new rear No. 2 differential mount cushion.
| *a | Arrow |
| *b | Matchmark |
Install the rear No. 2 differential mount cushion with the arrow marks facing upward and downward.
Using SST, install the rear No. 2 differential mount cushion.
| *1 | Rear Suspension Member |
| *2 | Rear No. 2 Differential Mount Cushion |
| *3 | SST(09571-01090) |
| *4 | SST(09571-01070) |
| *5 | SST(09571-01050) |
| *6 | SST(09571-01080) |
| *7 | SST(09571-01040) |
| *8 | SST(09571-01030) |
| *9 | SST(09571-01060) |
| *a | Hold |
| *b | Turn |
| *c | Start |
| *d | End |
|
Front side |
Install the rear No. 2 differential mount cushion while aligning with the matchmark on the rear suspension member and checking misalignment.
Push in the rear No. 2 differential mount cushion until SST (09571-01040) comes into contact with the rear suspension member.
Make sure that the differential mount cushion is aligned within 5° from the center.
| *a | 5° |
41651
2.INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION
Put matchmarks on the rear suspension member and new rear No. 1 differential mount cushion.
| *a | Triangle Mark |
| *b | Matchmark |
Install the rear No. 1 differential mount cushion with the triangle mark facing upward.
Using SST, install the rear No. 1 differential mount cushion.
| *1 | Rear Suspension Member |
| *2 | Rear No. 1 Differential Mount Cushion |
| *3 | SST(09571-01150) |
| *4 | SST(09571-01130) |
| *5 | SST(09571-01190) |
| *6 | SST(09571-01120) |
| *7 | SST(09571-01170) |
| *8 | SST(09571-01140) |
| *9 | SST(09571-01160) |
| *10 | SST(09571-01180) |
| *11 | SST(09922-10010) |
| *a | Hold |
| *b | Turn |
| *c | Start |
| *d | End |
|
Front side |
Install the rear No. 1 differential mount cushion while checking that SST and the rear No. 1 differential mount cushion are not at an angle.
If the rear No. 1 differential mount cushion is pushed in at an angle, the installation becomes difficult. Be sure to set SST on the rear No. 1 differential mount cushion with no clearance.
Install the rear No. 1 differential mount cushion while aligning with the matchmark on the rear suspension member and checking misalignment.
Push in the rear No. 1 differential mount cushion until SST (09571-01130) comes into contact with the rear suspension member.
Make sure that the differential mount cushion is aligned within 3° from the center.
| *a | 3° |
41110
3.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
48812
4.INSTALL REAR STABILIZER BAR
17430
5.INSTALL TAIL EXHAUST PIPE ASSEMBLY
41110
6.INSTALL DIFFERENTIAL CARRIER ASSEMBLY