Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM2090E _53 Suspension _060681 REAR SUSPENSION _0297606 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  INSTALLATION  


PROCEDURE

Hide 48790 1.TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH

a.

Temporarily install the rear upper control arm assembly LH to the rear suspension member sub-assembly with the 2 bolts and 2 new nuts.

NOTICE:
·

Insert the bolt from the rear side of the vehicle for the front side of the installation position.

·

Insert the bolt from the front side of the vehicle for the rear side of the installation position.




b.

Temporarily install the rear upper control arm assembly LH to the axle carrier with the new bolt and a new nut.

NOTICE:

Insert the bolt from the front side of the vehicle.



Hide 48770A 2.TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 51206A 3.INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

Hide 48790 5.FULLY TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH

a.

Fully tighten the nut on the axle carrier side of the upper control arm assembly LH.

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)


b.

Fully tighten the 2 nuts on the suspension member side of the upper control arm assembly LH.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 48770A 6.FULLY TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 7.INSPECT AND ADJUST REAR WHEEL ALIGNMENT

Hide 9. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)

Hide 10.ADJUST HEADLIGHT AIMING (w/ HID Headlight System)