Home › Suspension › REAR SUSPENSION › TOE CONTROL LINK
RM2090E _53 Suspension _060681 REAR SUSPENSION _0297608 TOE CONTROL LINK A

REAR SUSPENSION  TOE CONTROL LINK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

The procedure listed below is for the LH side.

·

Use the same procedure for the RH and LH sides.



PROCEDURE

Hide 48706B 1.TEMPORARILY INSTALL TOE CONTROL LINK SUB-ASSEMBLY LH

a.

Install the toe control link sub-assembly LH and insert the toe adjust cam from the front of the vehicle. Then, install the rear No. 2 suspension toe adjust plate and temporarily install the new nut.

NOTICE:

Align the matchmarks on the rear suspension member and the rear No. 2 suspension toe adjust plate.



b.

Install the rear suspension toe control link sub-assembly LH to the rear axle carrier side with a nut.

Torque:
60 N*m (612 kgf*cm, 44 ft.*lbf)


c.

Install the new snap pin.


Hide 48720A 2.TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

Hide 48706B 4.FULLY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH

a.

Fully tighten the nut on the rear suspension member side.

Torque:
100 N*m (1020 kgf*cm, 74 ft.*lbf)

NOTICE:

Check that the matchmarks on the rear suspension member and the rear No. 2 suspension toe adjust plate are aligned.



Hide 48720A 5.FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

Hide 6.INSTALL REAR WHEEL

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)

Hide 7.INSPECT AND ADJUST REAR WHEEL ALIGNMENT