Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297617 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1234  Yaw Rate Sensor  C1419  Acceleration Sensor Internal Circuit  C1472  Acceleration Sensor  C1474  Forward and Rearward G Sensor  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
C1234 Internal failure of the skid control ECU (Yaw rate sensor). Skid control ECU
C1419 Internal failure of the skid control ECU (Acceleration sensor).
C1472 Internal failure of the skid control ECU (Lateral G sensor).
C1474 Internal failure of the skid control ECU (Forward and backward G sensor).

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform VSC sensor neutral memorization (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK BRAKE ACTUATOR ASSEMBLY INSTALLATION
a.

Turn the ignition switch off.


b.

Check that the skid control ECU (brake actuator assembly) has been installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>INSTALLATION).

OK:

The skid control ECU (brake actuator assembly) should be tightened to the specified torque.

The skid control ECU (brake actuator assembly) should not be tilted.




OK

NG

INSTALL BRAKE ACTUATOR ASSEMBLY CORRECTLY