Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › 2012.03–2016.06
RM2090E _54 Brake _060684 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297621 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


PROCEDURE

Hide 89245B 2.INSTALL STEERING SENSOR

a.
B558545E01
1.719,1.323 2.708,0.635 2.708,0.635 1.729,0.635 true 2.76,0.573 3.219,0.948 0.458,0.375 10 false *a

Apply grease to the protrusions on the steering sensor.

Text in Illustration
*a Protrusion

NOTICE:
·

Do not rotate the steering sensor.

·

Apply the specified grease supplied with a new steering sensor.




b.
B313958E01
1.903,0.125 2.089,0.286 0.186,0.161 10 *1 3.175,0.574 3.361,0.735 0.186,0.161 10 *2 1.38,0.398 1.566,0.559 0.186,0.161 10 *2 1.927,0.933 2.113,1.094 0.186,0.161 10 *1 2.098,0.258 2.442,0.674 false 2.098,1.026 2.458,1.17 false 0.784,0.854 1.365,0.498 false 2.909,0.939 3.169,0.703 false

Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.

Text in Illustration
*1 Guide
*2 Pin

NOTICE:

Do not rotate the spiral cable until the steering sensor has been attached to it.



Hide 3. ALIGN FRONT WHEELS TO FACE STRAIGHT AHEAD

Hide 4.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45286 5.INSTALL UPPER STEERING COLUMN COVER

Hide 45289A 7.INSTALL STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

Hide 55422 8.INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT

Hide 55405B 10.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 11.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 55606 12.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 55318C 13.REMOVE AND INSTALL INSTRUMENT SIDE PANEL (w/o Knee Airbag)

Hide 14.ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45111 15.INSTALL STEERING WHEEL ASSEMBLY