Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for RHD)
RM2090E _54 Brake _060685 BRAKE SYSTEM (OTHER) _0297626 BRAKE BOOSTER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for RHD)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.


b.
C105620E08
1.917,1.198 1.917,1.552 false 2.24,1.208 2.24,1.563 false 1.708,0.26 1.948,0.458 0.24,0.198 10 false *a 1.844,1.573 2,1.719 0.156,0.146 10 false *1 2.167,1.573 2.323,1.719 0.156,0.146 10 false *2

Set the push rod length as shown in the illustration.

Text in Illustration
*1 Lock Nut
*2 Brake Master Cylinder Push Rod Clevis
*a Push Rod Length

Push rod length:

155.2 mm (6.11 in.)



c.

Tighten the lock nut.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 44610 2.INSTALL BRAKE BOOSTER ASSEMBLY

a.

Install the brake booster assembly to the vehicle body with the 4 nuts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:

Do not kink or damage the brake lines.



Hide 35000 4.REMOVE AND INSTALL TCM (for Automatic Transmission)

Hide 73900 5.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY (w/ Knee Airbag)

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

Hide 55317A 7.INSTALL INSTRUMENT SIDE PANEL RH (w/o Knee Airbag)

Hide 47201 8.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 9.INSPECT AND ADJUST BRAKE PEDAL