Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2016.06
RM2090E _58 Vehicle Interior _060699 METER / GAUGE / DISPLAY _0297701 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Tachometer Malfunction  


DESCRIPTION

The combination meter assembly controls the tachometer in accordance with the engine speed signals from the ECM through the CAN communication system.

WIRING DIAGRAM

E357051E04
2.74,1.729 4.344,1.938 1.604,0.208 10 false CAN Communication Line 1.927,2.823 2.281,3.021 0.354,0.198 10 false ECM 4.781,2.771 4.99,2.948 0.208,0.177 10 false D7 1.354,2.823 1.708,3.021 0.354,0.198 10 false A33 4.781,2.938 6.26,3.292 1.479,0.354 10 false Combination Meter Assembly

PROCEDURE

1.CHECK FOR DTC (METER / GAUGE SYSTEM)
a.

Check if meter gauge system DTCs are output (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).

OK:

DTCs are not output.




OK

2.CHECK FOR DTC (SFI SYSTEM)

NG

2.CHECK FOR DTC (SFI SYSTEM)
a.

Check if the SFI system outputs DTCs (See page Engine / Hybrid System>FA20 (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR).

OK:

DTCs are not output.




OK

3.PERFORM ACTIVE TEST USING GTS (TACHOMETER OPERATION)

NG

3.PERFORM ACTIVE TEST USING GTS (TACHOMETER OPERATION)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the tester, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Tachometer Operation Tachometer 0, 1000, 2000, 3000, , 4000, 5000, 6000, 7000 rpm -

OK:

The engine speed displayed on the tester is approximately the same as that of the tachometer reading.




OK

NG

REPLACE COMBINATION METER ASSEMBLY