The combination meter assembly controls the engine coolant temperature receiver gauge in accordance with the engine coolant temperature sensor signals from the ECM through the CAN communication system.
Check if CAN communication DTCs are output (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Water Temperature Meter Operation | Water temperature gauge | LOW, NORMAL, HIGH | Vehicle is stopped and engine is idling |
The value selected during Active Test is displayed.
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Coolant Temperature | Engine coolant temperature
Min.: 0 (0) Max.: 127.5 (261.5) |
After warming up: 80 to 108 (176 to 226) | Unit: °C ( °F) |
The vehicle's coolant temperature and tester value are the same.
OK
NG
Check if the SFI system outputs DTCs (See page Engine / Hybrid System>FA20 (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
(See pageEngine / Hybrid System>FA20 (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Coolant Temp | Coolant temperature
Min.: -40 (-40) Max.: 215 (419) |
After warming up: 75 to 100 (167 to 212) | Unit: °C ( °F) |
The vehicle's coolant temperature and tester value are the same.
OK
NG
(See pageEngine / Hybrid System>FA20 (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Replace the combination meter assembly with a new or a normal one (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
The operation of the engine coolant temperature returns to normal.
OK
NG