45111
1.REMOVE STEERING WHEEL ASSEMBLY
2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
3.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Check that the front wheels are facing straight ahead.
Check that the spiral cable with sensor sub-assembly is center position.
The connector is at the top.
The colored roller or the top of the flat cable U-turn can be checked from the check window.
| *A | Colored Roller (Visible Type) | *B | Flat Cable (Visible Type) |
| *a | Check Window | *b | Colored Roller |
| *c | Top of Flat Cable U-turn | - | - |
If the result is not as specified, it is possible that the spiral cable sub-assembly is broken. Replace the spiral cable sub-assembly with a new one.
73900
4.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY (w/ Knee Airbag)
55318C
5.REMOVE INSTRUMENT SIDE PANEL (w/o Knee Airbag)
55606
6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
55405B
7.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55403
8.REMOVE METER HOOD SUB-ASSEMBLY
55422
9.REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT
45289A
10.REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)
11.REMOVE LOWER STEERING COLUMN COVER
45286
12.REMOVE UPPER STEERING COLUMN COVER
13.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch ON.
Do not rotate the spiral cable sub-assembly without the steering wheel with the battery connected and the ignition switch ON.
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Check that the front wheels are facing straight ahead.
Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.
| *1 | Slider |
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Disconnect the other connector from the spiral cable with sensor sub-assembly.
Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.
14.REMOVE SPIRAL CABLE SUB-ASSEMBLY
Remove the spiral cable sub-assembly from the steering sensor only when replacing it or the steering sensor.
Do not rotate the center section of the steering sensor, as it may deviate from the steering sensor neutral point.
Disengage the 6 claws, 2 pins and 2 guides to remove the spiral cable sub-assembly from the steering sensor.
Do not damage the guide and claw.
| *1 | Guide |
| *2 | Pin |