Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY
RM2090E _58 Vehicle Interior _060703 SEAT BELT _0297729 REAR SEAT OUTER BELT ASSEMBLY A

SEAT BELT  REAR SEAT OUTER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 73370 1.INSPECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

Hide 73370 2.INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

a.
B311341E01
2.21,1.115 2.396,1.276 0.186,0.161 10 A 0.082,0.243 0.268,0.404 0.186,0.161 10 B

Tighten the bolt B to temporarily install the rear seat 3 point type outer belt assembly.


b.

Install the bolt A.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


c.

Check if the ELR locks.

NOTICE:

The check should be performed with the rear seat 3 point type outer belt assembly installed.


i.

With the rear seat 3 point type outer belt assembly installed, check that the belt locks when it is pulled out quickly.



d.
B311340E01
2.296,0.28 2.482,0.441 0.186,0.161 10 *1 1.983,1.173 2.272,0.37 2.272,0.37 1.644,0.565 false

Connect the floor anchor of the rear seat 3 point type outer belt assembly with the bolt.

Text in Illustration
*1 Protruding Part

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

Do not allow the anchor part of the rear seat 3 point type outer belt assembly to overlap the protruding parts of the floor panel.



Hide 62606A 4.INSTALL QUARTER TRIM LID SUB-ASSEMBLY

Hide 64715D 5.INSTALL LUGGAGE COMPARTMENT TRIM COVER

Hide 62312B 6.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 71470S 8.INSTALL SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY