53630
1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
Pass the hood lock control cable assembly into the engine compartment.
| *1 | Hood Lock Control Cable | *2 | Grommet |
| *3 | Hood Cable Grommet | *4 | Matchmark |
Engage 7 clamps shown in the illustration.
53510
2.INSTALL HOOD LOCK ASSEMBLY
Apply MP grease to the sliding areas of the hood lock assembly.
Connect the hood lock control cable assembly to the hood lock assembly.
Install the hood lock assembly with the 3 bolts in the order shown in the illustration.
53601
3.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
Install the hood lock control lever sub-assembly with the bolt
53301
4.INSPECT HOOD SUB-ASSEMBLY
53301
5.ADJUST HOOD SUB-ASSEMBLY
17701
6.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
62111C
7.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
67913
8.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).