Home › Power Source / Network › FA20 (BATTERY / CHARGING) › CHARGING SYSTEM (for 150 A Type) › from 2019.03
RM2090E _57 Power Source / Network _060693 FA20 BATTERY / CHARGING _0396238 CHARGING SYSTEM(for 150 A Type) C

FA20 BATTERY / CHARGING  CHARGING SYSTEM(for 150 A Type)  U0077  LIN Communication Bus "ECM/PCM" Off  


DESCRIPTION

The ECM outputs DTC U0077 when the following conditions are met.

DTC Code DTC Detection Condition Trouble Area
U0077 Both of the following conditions are met for 1.24 seconds:
·

The battery voltage is 10.9 V or more.

·

LIN communication bus error with the ECM is detected.


·

Wire harness or connector

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.



e.

Turn the ignition switch off and wait at least 30 seconds.


f.

Enter the following menus: Powertrain / Engine / Trouble Codes.



Result:
Result Proceed to
DTC U0077 is output A
DTC is not output B


A

2.CHECK FOR HARNESS AND CONNECTOR (ECM - BATTERY STATE SENSOR (BATTERY NEGATIVE TERMINAL))

B

2.CHECK FOR HARNESS AND CONNECTOR (ECM - BATTERY STATE SENSOR (BATTERY NEGATIVE TERMINAL))
a.

Turn the ignition switch off.


b.

Disconnect the ECM connector.


c.

Disconnect the battery state sensor (battery negative terminal) connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A33-21 (LIN) - A78-2 (LIN) Always Below 1 Ω




OK

3.CHECK HARNESS AND CONNECTOR (ECM - BATTERY STATE SENSOR (BATTERY NEGATIVE TERMINAL))

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

3.CHECK HARNESS AND CONNECTOR (ECM - BATTERY STATE SENSOR (BATTERY NEGATIVE TERMINAL))
a.

Turn the ignition switch off.


b.

Disconnect the ECM connector.


c.

Disconnect the battery state sensor (battery negative terminal) connector.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A33-21 (LIN) - Body ground Always 10 kΩ or higher




OK

4.CHECK HARNESS AND CONNECTOR (ECM - BATTERY STATE SENSOR (BATTERY NEGATIVE TERMINAL))

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

4.CHECK HARNESS AND CONNECTOR (ECM - BATTERY STATE SENSOR (BATTERY NEGATIVE TERMINAL))
a.

Turn the ignition switch ON.


b.

Disconnect the ECM connector.


c.

Disconnect the battery state sensor (battery negative terminal) connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A33-21 (LIN) - Body ground Always Below 1 V




OK

5.CHECK FOR DTC

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

5.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.



e.

Turn the ignition switch off and wait at least 30 seconds.


f.

Enter the following menus: Powertrain / Engine / Trouble Codes.



Result:
Result Proceed to
DTC U0077 is output A
DTC is not output B


A

B