Home › Engine / Hybrid System › 3SZ-VE ENGINE CONTROL › SFI SYSTEM(w/ Rear Heated Oxygen Sensor) › 2011.11–2015.08
RM19Y0E _51 Engine / Hybrid System _002968 3SZ-VE ENGINE CONTROL _0014988 SFI SYSTEM(w/ Rear Heated Oxygen Sensor) C

3SZ-VE ENGINE CONTROL  SFI SYSTEM(w/ Rear Heated Oxygen Sensor)  P0016  Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)  


DESCRIPTION

In the VVT (Variable Valve Timing) system, the appropriate intake valve open and close timing is controlled by the ECM. The ECM performs intake valve control by performing the following: 1) controlling the camshaft and camshaft timing oil control valve, and operating the camshaft timing gear; and 2) changing the relative positions of the gaps between the camshaft and crankshaft.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0016 Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)
·

Crankshaft timing and camshaft timing not synchronized twice in succession under valve timing control

·

5 trip detection logic

·

Chain timing malfunction



·

Crankshaft timing and camshaft timing not synchronized twice in succession under valve timing control

·

2 trip detection logic

·

Valve timing malfunction



·

Mechanical system (Timing chain has jumped tooth or chain stretched)

·

Valve timing

·

ECM


- DTC stored

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the intelligent tester or Techstream. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.


PROCEDURE

1.CHECK VALVE TIMING (CHECK FOR LOOSENESS AND JUMPED TOOTH OF TIMING CHAIN)

OK

2.REPLACE TIMING CHAIN SUB-ASSEMBLY

NG

3.ADJUST VALVE TIMING
2.REPLACE TIMING CHAIN SUB-ASSEMBLY
a.

Replace timing chain sub-assembly.

Click hereEngine / Hybrid System>3SZ-VE ENGINE MECHANICAL>ENGINE UNIT>DISASSEMBLY

Result:
Proceed to
NEXT




NEXT

4.CHECK WHETHER DTC OUTPUT RECURS (P0016)
3.ADJUST VALVE TIMING
a.

Adjust the valve timing.

Click hereEngine / Hybrid System>3SZ-VE ENGINE MECHANICAL>VALVE CLEARANCE>ADJUSTMENT

Result:
Proceed to
NEXT




NEXT

4.CHECK WHETHER DTC OUTPUT RECURS (P0016)
4.CHECK WHETHER DTC OUTPUT RECURS (P0016)
NOTICE:

After replacing the ECM or adjusting intake valve timing, confirm that the DTC output does not recur.


a.

Connect the intelligent tester or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester or Techstream on.



e.

Start the engine and warm it up.


f.

Allow the engine to idle for 1 minute or more, and then drive the vehicle for 1 minute or more.


g.

Turn the ignition switch off.


h.

Repeat steps (e) and (f) at least 5 times, in order to set DTCs (using 5 trip detection logic).


i.

Read the DTCs.

Powertrain > Engine > Trouble Codes
50001 206
OK:

No DTC output


Result:
Proceed to
NEXT




NEXT

END