Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(for 3SZ-VE) › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002984 CLUTCH _0015093 CLUTCH MASTER CYLINDER(for 3SZ-VE) A

CLUTCH  CLUTCH MASTER CYLINDER(for 3SZ-VE)  INSTALLATION  


PROCEDURE

Hide 31410 1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install the clutch master cylinder assembly with the bolt and nut.

Torque:
18 N*m (185 kgf*cm, 13 ft.*lbf)


b.

Apply MP grease to the pin.


c.

Install the clutch master cylinder push rod clevis with the wave washer, pin and clip.


Hide 55106 2.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for LHD)

a.

Install the brake pedal support sub-assembly with the 4 bolts and 4 nuts.

Torque:
BOLTS : 21 N*m (214 kgf*cm, 16 ft.*lbf)
NUTS : 13 N*m (131 kgf*cm, 9.5 ft.*lbf)


Hide 3.INSTALL CLUTCH PEDAL BRACKET (for RHD)

a.

Install the clutch pedal bracket with the nut and 2 bolts.

Torque:
21 N*m (214 kgf*cm, 16 ft.*lbf)


Hide 31481 4.INSTALL NO. 1 CLUTCH RELEASE TUBE

a.

Using union nut wrench (10 mm), install the No. 1 clutch release tube.

Torque:
15 N*m (154 kgf*cm, 11 ft.*lbf)

HINT:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 5.CONNECT NO. 1 CLUTCH RESERVOIR HOSE

a.

Connect the No. 1 clutch reservoir hose.


Hide 45250 6.INSTALL STEERING COLUMN ASSEMBLY

Hide 7. FILL RESERVOIR WITH BRAKE FLUID

Hide 31301 9.INSPECT AND ADJUST CLUTCH PEDAL HEIGHT

Hide 10.INSPECT FOR BRAKE FLUID LEAK