Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2011.11–2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015137 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the intelligent tester to the vehicle and reading various data output from the skid control ECU (brake actuator assembly).

The skid control ECU (brake actuator assembly) stores DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.

To check the DTCs, connect the intelligent tester to the DLC3 of the vehicle. The intelligent tester enables you to clear the DTCs, activate various actuators, and check the freeze frame data and Data List.

a.

Check the battery voltage.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge the battery before proceeding to the next step.



DIAGNOSIS


a.

If the skid control ECU (brake actuator assembly) detects a malfunction, the ABS warning light and brake warning light will come on in order to warn the driver.


b.
C249767C11
1.604,0.771 1.417,0.354 true 1.844,1.427 1.844,1.792 true 1.365,0.188 1.667,0.49 0.302,0.302 10 E 1.677,1.813 2.25,2.094 0.573,0.281 10 ECUT 0.167,0.125 0.531,0.427 0.365,0.302 10 *a
*a Front view of DLC3


DTCs are simultaneously stored in memory. Output DTCs can be read by connecting SST to terminals 13 (ECUT) and 4 (E) of the DLC3 and observing the blinking pattern of the ABS warning light or by connecting the intelligent tester (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).


c.

This system has a test mode (signal check) function (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).



WARNING LIGHT INITIAL CHECK


a.

Release the parking brake.

CAUTION:

When releasing the parking brake, set chocks to hold the vehicle for safety.


HINT:

When the parking brake is applied or the level of the brake fluid is low, the brake warning light comes on.



b.

When the ignition switch is turned to ON, check that the ABS warning light and brake warning light come on for approximately 3 seconds.

HINT:

If the warning light check result is not normal, proceed to troubleshooting for the ABS warning light and brake warning light circuits.


If an indicator remains on or does not come on, proceed to troubleshooting for the light circuits listed below.

Trouble Area See procedure
ABS warning light circuit (Remains on) See page (Click here)
ABS warning light circuit (Does not come on) See page (Click here)
Brake warning light circuit (Remains on) See page (Click here)
Brake warning light circuit (Does not come on) See page (Click here)