Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(for LHD) › 2011.11–2015.08
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015145 BRAKE MASTER CYLINDER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for LHD)  INSTALLATION  


PROCEDURE

Hide 47201 1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Apply lithium base glycol grease to a new O-ring.


b.

Install the O-ring onto the brake master cylinder sub-assembly.


c.

Install the brake master cylinder sub-assembly with the 2 nuts.

Torque:
13 N*m (128 kgf*cm, 9 ft.*lbf)


d.

Using union nut wrench, install the 2 brake tubes onto the brake master cylinder sub-assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



e.

Connect the brake fluid level warning switch connector.


Hide 31481A 2.CONNECT NO. 1 CLUTCH HOSE (for 3SZ-VE with Manual Transmission)

a.

Connect the No. 1 clutch hose with the clip.


Hide 44510 3.INSTALL BRAKE ACTUATOR ASSEMBLY (for LHD with ABS)

Hide 4. FILL RESERVOIR WITH BRAKE FLUID

Hide 5.BLEED CLUTCH LINE (for 3SZ-VE with Manual Transmission)

Hide 9.INSPECT FOR BRAKE FLUID LEAK