If there is a short in this circuit, the stereo component tuner detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the stereo component tuner or speakers.
If a short is detected in the speaker circuit, no sound can be heard from the speakers.
Remove the stereo component tuner assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL
Remove the front door speaker assemblies.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Remove the pillar speaker assemblies (for 6 speakers).
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER>REMOVAL
Remove the rear door speaker assemblies.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Measure the resistance between each of the front door speaker assembly and the stereo component tuner assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E4-2 (SPL+) - G1-1 | Always | Below 1 Ω |
| E4-6 (SPL-) - G1-2 | Always | Below 1 Ω |
| E4-1 (SPR+) - F1-1 | Always | Below 1 Ω |
| E4-5 (SPR-) - F1-2 | Always | Below 1 Ω |
Measure the resistance between each of the pillar speaker assembly and the stereo component tuner assembly to check for an open circuit in the wire harness (for 6 speakers).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E4-2 (SPL+) - E2-1 | Always | Below 1 Ω |
| E4-6 (SPL-) - E2-2 | Always | Below 1 Ω |
| E4-1 (SPR+) - E37-1 | Always | Below 1 Ω |
| E4-5 (SPR-) - E37-2 | Always | Below 1 Ω |
Measure the resistance between each of the rear door speaker assembly and the stereo component tuner assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E6-2 (SRL+) - I1-1 | Always | Below 1 Ω |
| E6-6 (SRL-) - I1-2 | Always | Below 1 Ω |
| E6-1 (SRR+) - H1-1 | Always | Below 1 Ω |
| E6-3 (SRR-) - H1-2 | Always | Below 1 Ω |
Measure the resistance between each speaker assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E4-1 (SPR+) - Body ground | Always | 10 kΩ or higher |
| E4-2 (SPL+) - Body ground | Always | 10 kΩ or higher |
| E4-5 (SPR-) - Body ground | Always | 10 kΩ or higher |
| E4-6 (SPL-) - Body ground | Always | 10 kΩ or higher |
| E6-1 (SRR+) - Body ground | Always | 10 kΩ or higher |
| E6-2 (SRL+) - Body ground | Always | 10 kΩ or higher |
| E6-3 (SRR-) - Body ground | Always | 10 kΩ or higher |
| E6-6 (SRL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the front door speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Result | Proceed to |
|---|---|
| OK (for 6 speakers) | A |
| OK (for 4 speakers) | B |
| NG | C |
A
B
C
Inspect the pillar speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the rear door speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
The speaker should not be removed to check resistance.
| Proceed to |
|---|
| OK |
| NG |
OK
NG