The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
73237A
1.REMOVE SHOULDER BELT ANCHOR COVER
| *1 | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the shoulder belt anchor cover.
Use the same procedure as for the both the rear No. 1 seat outer belt assembly side and rear No. 2 seat outer assembly side.
73560
2.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY
Loosen the bolt and remove it with the shoulder anchor.
Loosen the bolt and remove it with the floor anchor plate.
67917C
3.REMOVE REAR DOOR SCUFF PLATE (for Full-trim)
67935
4.REMOVE BACK DOOR SCUFF PLATE (for Full-trim)
64730B
5.REMOVE DECK TRIM SIDE PANEL ASSEMBLY (for Full-trim)
73360C
6.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (for Semi-trim)
73431A
7.REMOVE REAR SEAT BELT RETRACTOR COVER (for Semi-trim)
62520P
8.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH (for Semi-trim LH Side)
62510P
9.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH (for Semi-trim RH Side)
73560
10.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY
Loosen the bolt and disengage the 2 guides to remove the rear No. 2 seat outer belt assembly with the bolt.