1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.DRAIN ENGINE COOLANT
87245X
4.REMOVE NO. 1 HEATER WATER HOSE (w/ Heater)
Slide the clip and disconnect the No. 1 heater water hose from the air conditioning unit assembly.
Use the same procedure for the RHD and LHD vehicles.
87246X
5.REMOVE NO. 2 HEATER WATER HOSE (w/ Heater)
Slide the clip and disconnect the No. 2 heater water hose from the air conditioning unit assembly.
Use the same procedure for the RHD and LHD vehicles.
88717U
6.SEPARATE SUCTION TUBE SUB-ASSEMBLY (for RHD)
Remove the bolt.
Turn the hook connector clockwise and disconnect the suction tube sub-assembly.
Remove the O-ring from the suction tube sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88717U
7.SEPARATE SUCTION TUBE SUB-ASSEMBLY (for LHD)
Remove the bolt.
Turn the hook connector counterclockwise and disconnect the suction tube sub-assembly.
Remove the O-ring from the suction tube sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88716A
8.SEPARATE LIQUID TUBE SUB-ASSEMBLY (for RHD)
Disconnect the liquid tube sub-assembly.
Remove the O-ring from the liquid tube sub-assembly.
Seal the opening of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88716A
9.SEPARATE LIQUID TUBE SUB-ASSEMBLY (for LHD)
Disconnect the liquid tube sub-assembly.
Remove the O-ring from the liquid tube sub-assembly.
Seal the opening of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
10.REMOVE FRONT SEAT ASSEMBLY
55302A
11.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
55303B
12.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
45250
13.REMOVE STEERING COLUMN ASSEMBLY
89561
14.REMOVE ECM (for RHD)
89561
15.REMOVE ECM (for LHD)
89530C
16.REMOVE TCM (for Automatic Transmission)
85918A
17.REMOVE DOOR CONTROL RELAY (w/o Wireless Door Lock)
89743
18.REMOVE DOOR CONTROL RECEIVER (w/ Wireless Door Lock)
55453D
19.REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD (for RHD)
Disengage the 2 clamps and remove the No. 1 instrument panel safety pad.
55454B
20.REMOVE NO. 2 INSTRUMENT PANEL SAFETY PAD (for RHD)
Use the same procedure as for the No. 1 instrument panel safety pad.
82600
21.REMOVE RELAY BLOCK ASSEMBLY (for RHD)
Disconnect each connector.
Remove the 3 bolts and the relay block assembly.
82600
22.REMOVE RELAY BLOCK ASSEMBLY (for LHD)
Disconnect each connector.
Remove the 3 bolts and the relay block assembly.
82141
23.SEPARATE INSTRUMENT PANEL WIRE (for RHD)
Disconnect the 2 connectors and disengage the 2 clamps.
Disconnect the connector and disengage the 4 clamps.
Remove the bolt and disconnect the ground wire from the instrument panel reinforcement.
Disengage the 3 clamps and remove the instrument panel wire from the instrument panel reinforcement.
Remove the bolt and disconnect the ground wire from the instrument panel reinforcement.
Disengage the 2 clamps and remove the instrument panel wire from the instrument panel reinforcement.
82141
24.SEPARATE INSTRUMENT PANEL WIRE (for LHD)
Disconnect the 2 connectors and disengage the clamp.
Remove the bolt and disconnect the ground wire from the instrument panel reinforcement.
Disengage the 3 clamps and remove the instrument panel wire from the instrument panel reinforcement.
Disconnect the connector and disengage the clamp.
Disconnect the connector and disengage the clamp.
Remove the bolt and disconnect the ground wire from the instrument panel reinforcement.
Disengage the 3 clamps and remove the instrument panel wire from the instrument panel reinforcement.
Remove the bolt and disconnect the ground wire from the instrument panel reinforcement.
Disengage the 3 clamps and remove the instrument panel wire from the instrument panel reinforcement.
Disengage the 2 camps.
Remove the 2 bolts and disconnect the ground wire from the instrument panel reinforcement.
87220
25.REMOVE AIR DUCT ASSEMBLY
Remove the 2 bolts and air duct assembly.
Use the same procedure for the RHD and LHD vehicles.
88539J
26.SEPARATE DRAIN COOLER HOSE
Separate the drain cooler hose from the vehicle.
Use the same procedure for the RHD and LHD vehicles.
55331
27.REMOVE INSTRUMENT PANEL REINFORCEMENT (for RHD)
Remove the bolt from the engine compartment.
Remove the 2 bolts from the front pillar.
Use the same procedure for the LH side and RH side.
Remove the 5 bolts and the instrument panel reinforcement with the air conditioning unit assembly.
55331
28.REMOVE INSTRUMENT PANEL REINFORCEMENT (for LHD)
Remove the bolt from the engine compartment.
Remove the 2 bolts from the front pillar.
Use the same procedure for the LH side and RH side.
Remove the 4 bolts and the instrument panel reinforcement with the air conditioning unit assembly.
29.REMOVE AIR CONDITIONING UNIT ASSEMBLY (for RHD)
Remove the 2 bolts, nut and air conditioning unit assembly from the instrument panel reinforcement.
30.REMOVE AIR CONDITIONING UNIT ASSEMBLY (for LHD)
Remove the 2 bolts, nut and air conditioning unit assembly from the instrument panel reinforcement.