Home › Engine / Hybrid System › 2NR-VE LUBRICATION › LUBRICATION SYSTEM › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042284 2NR-VE LUBRICATION _0196247 LUBRICATION SYSTEM G

2NR-VE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up and stop the engine, then wait for 5 minutes.


b.

Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.

If the level is low, check for engine oil leaks and add engine oil to the full level mark.

NOTICE:

Do not add engine oil above the full level mark.


HINT:

A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.

·

When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.

·

If low quality oil or oil of an inappropriate viscosity is used.

·

When driving at high engine speeds or with a heavy load, (when towing, etc.), or when accelerating or decelerating frequently while driving.

·

When leaving the vehicle idling for a long time, or when driving frequently in heavy traffic.


When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.



Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the engine oil for deterioration, water intrusion, discoloration or thinning.

If the quality is visibly poor, replace the engine oil.


Hide 3.CHECK ENGINE OIL PRESSURE

a.

Remove the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>2NR-VE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL

CAUTION:

Make sure the engine is cold when removing the engine oil pressure switch assembly to prevent burns caused by hot engine oil.



b.
A361316

Install an oil pressure gauge.


c.

Install the front No. 1 engine mounting bracket RH.

Click hereEngine / Hybrid System>2NR-VE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION


d.

Install the cooler compressor assembly.

Click hereEngine / Hybrid System>2NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION


e.

Install the fan and generator V belt.

Click hereEngine / Hybrid System>2NR-VE ENGINE MECHANICAL>DRIVE BELT>INSTALLATION


f.

Install the No. 3 air cleaner pipe bracket.

Click hereEngine / Hybrid System>2NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION




i.

Install the air cleaner inlet assembly.

Click hereEngine / Hybrid System>2NR-VE ENGINE MECHANICAL>ENGINE ASSEMBLY>INSTALLATION


j.

Warm up the engine.

HINT:

After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).



k.

Check the engine oil pressure.

Standard Engine Oil Pressure:
At Idle At 3000 rpm
30 kPa (0.3 kgf/cm2, 4.4 psi) or more 180 to 550 kPa (1.8 to 5.6 kgf/cm2, 26 to 80 psi)


If the result is not as specified, check the quality of the engine oil and check the oil paths for clogging. Repair or replace if necessary. If the engine oil pressure is still not as specified, replace the timing chain cover sub-assembly.

HINT:

Replace the timing chain cover sub-assembly as the engine oil pump is built into the timing chain cover sub-assembly.



l.

Remove an oil pressure gauge.


m.

Install the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>2NR-VE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION