Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › from 2015.08
RM19Y0E _59 Vehicle Exterior _003020 LIGHTING (EXT) _0015281 LIGHTING SYSTEM Y

LIGHTING (EXT)  LIGHTING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the lighting system.

·

*: Use the GTS or Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.INSPECT CAN COMMUNICATION SYSTEM*
3.INSPECT CAN COMMUNICATION SYSTEM*
a.

Use the GTS or Techstream to check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication system DTC is not output. A
CAN communication system DTC is output. B



A

4.PROBLEM SYMPTOMS TABLE

B

4.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

(Click here Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>PROBLEM SYMPTOMS TABLE)

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B




A

5.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

6.ADJUST, REPAIR OR REPLACE
5.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

6.ADJUST, REPAIR OR REPLACE
6.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END