Factors that affect the indicated vehicle speed include tire size, tire inflation, and tire wear. The speed indicated on the speedometer has an allowable margin of error. For details about testing and the margin of error, see the reference chart
The combination meter assembly controls the speedometer in accordance with vehicle speed signals from the ECM and skid control ECU (brake actuator assembly) through the CAN communication system.
If the vehicle speed sensor circuit has a malfunction, the ECM or skid control ECU (brake actuator assembly) stores DTCs. Troubleshoot the SFI system or anti-lock brake system.
for 1NR-VE
Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR
for 2NR-VE (w/Air Fuel Ratio Sensor)
Click hereEngine / Hybrid System>2NR-VE ENGINE CONTROL>SFI SYSTEM(w/ Air Fuel Ratio Sensor)>DTC CHECK / CLEAR
for 2NR-VE (w/o Air Fuel Ratio Sensor)
Click hereEngine / Hybrid System>2NR-VE ENGINE CONTROL>SFI SYSTEM(w/o Air Fuel Ratio Sensor)>DTC CHECK / CLEAR
Inspect the fuses for circuits related to this system before performing the following procedure.
Check if CAN communication DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication DTCs are not output. | A |
| CAN communication DTCs are output. | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus:
for ABS: Chassis / ABS / Data List.
for A/T: Powertrain / A/T / Data List.
According to the display on the GTS or Techstream, read the Data List.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Speed | Maximum wheel speed sensor reading | Min.: 0 km/h (0 mph)
Max.: 326.4 km/h (203 mph) |
Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Speed | Vehicle speed | Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph) |
Same as speedometer indication | - |
The vehicle speed displayed on the GTS or Techstream is approximately the same as the actual vehicle speed.
Determine whether the value displayed on the GTS or Techstream is within the acceptable range by referring to the reference values described in "OPERATION CHECK".
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>OPERATION CHECK
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1NR-VE) | B |
| NG (for 2NR-VE( w/ Air Fuel Ratio Sensor)) | C |
| NG (for 2NR-VE( w/o Air Fuel Ratio Sensor)) | D |
A
B
Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
C
D
Replace the combination meter assembly with a new one.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
The operation of the speedometer returns to normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1NR-VE) | B |
| NG (for 2NR-VE) | C |
A
B
C