51443
1.REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)
2.DRAIN DIFFERENTIAL OIL
Remove the rear axle housing filler plug, rear axle housing drain plug and 2 gaskets, and then drain the oil.
Install the rear axle housing drain plug with a new gasket.
Make sure that the oil temperature is low before servicing, as the oil may be hot after driving.
3.DRAIN MANUAL TRANSMISSION OIL (for Manual Transmission)
4.DRAIN AUTOMATIC TRANSMISSION FLUID (for Automatic Transmission)
37110
5.REMOVE PROPELLER SHAFT ASSEMBLY
6.REMOVE REAR DRIVE PINION NUT
Using SST and a hammer, unstake the nut.
| *A | for Manual Transmission |
| *B | for Automatic Transmission |
Using SST, hold the flange and remove the nut.
for Manual Transmission:
for Automatic Transmission:
41204
7.REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY
Using SST, remove the companion flange.
For the AT model, a bolt (40 mm M 10 x 1.25) should be used to install SST (09955-03030) to the flange.
8.REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL
Using SST, remove the rear differential carrier oil seal.
9.INSTALL REAR DIFFERENTIAL CARRIER OIL SEAL
Using SST and a hammer, install a new oil seal.
0 to 1.0 mm (0 to 0.039 in.)
Evenly tap in the oil seal so that it is correctly installed.
Apply MP grease to the oil seal lip.
41204
10.INSTALL REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY
install the companion flange to the differential carrier.
11.INSTALL REAR DRIVE PINION NUT (for Manual Transmission)
Install the washer.
Using SST to hold the flange, tighten a new nut.
| *1 | Chisel |
| *a | Right |
| *b | Wrong |
Using a chisel and a hammer, stake the nut.
12.INSTALL REAR DRIVE PINION NUT (for Automatic Transmission)
Install the washer.
Using SST to hold the flange, tighten a new nut.
| *1 | Chisel |
| *a | Right |
| *b | Wrong |
Using a chisel and a hammer, stake the nut.
37110
13.TEMPORARILY TIGHTEN PROPELLER SHAFT ASSEMBLY
37110
14.FULLY TIGHTEN PROPELLER SHAFT ASSEMBLY
15.ADD MANUAL TRANSMISSION OIL (for Manual Transmission)
16.INSPECT MANUAL TRANSMISSION OIL (for Manual Transmission)
17.ADD AUTOMATIC TRANSMISSION FLUID (for Automatic Transmission)
18.INSPECT AUTOMATIC TRANSMISSION FLUID LEVEL (for Automatic Transmission)
19.ADD DIFFERENTIAL OIL
20.INSPECT FOR OIL LEAK
51443
21.INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)