Refer to DTC P0134.
Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>SFI SYSTEM>P0134
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0135 | Oxygen Sensor Heater (Front) System Malfunction | Open or short in oxygen sensor heater circuit for 1.28 seconds or more
(1 trip detection logic) |
·
Open or short in oxygen sensor heater circuit ·
Oxygen sensor heater ·
ECM |
Comes on | DTC stored |
Refer to DTC P0132.
Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>SFI SYSTEM>P0132
Read freeze frame data using the GTS. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
Disconnect the oxygen sensor connector.
Remove the No. 1 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C22-2 (HTR+) - 1J-3 | Always | Below 1 Ω |
| C22-2 (HTR+) or 1J-3 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Oxygen Sensor) |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connections | Switch Condition | Specified Conditions |
|---|---|---|
| C22-2 (HTR+) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the oxygen sensor.
Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>HEATED OXYGEN SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the oxygen sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C50-8 (OXH1) - C22-1 (HTR-) | Always | Below 1 Ω |
| C50-8 (OXH1) or C22-1 (HTR-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG