Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2016.09
RM19Y0E _58 Vehicle Interior _003008 METER / GAUGE / DISPLAY _0015206 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Tachometer Malfunction  


DESCRIPTION

In this circuit, the combination meter assembly receives engine speed signals from the ECM using the CAN communication system. The combination meter assembly displays the engine speed calculated based on the data received from the ECM.

WIRING DIAGRAM

E324172E01
0.427,1.448 2.615,1.708 2.188,0.26 10 false : CAN Communication Line 1.573,1.125 2.24,1.542 0.667,0.417 10 false ECM 4.51,1.135 6.698,1.521 2.188,0.385 10 false Combination Meter Assembly

PROCEDURE

1.CHECK FOR DTC (METER / GAUGE SYSTEM)
a.

Check if meter / gauge system DTCs are output.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR

OK:

DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.CHECK FOR DTC (SFI SYSTEM)

NG

2.CHECK FOR DTC (SFI SYSTEM)
a.

Check if SFI system DTCs are output.


OK:

DTCs are not output.



Result:
Result Proceed to
OK A
NG (for 1NR-VE). B
NG (for 2NR-VE (w/ Air Fuel Ratio Sensor)). C
NG (for 2NR-VE (w/o Air Fuel Ratio Sensor)). D



A

3.PERFORM ACTIVE TEST USING GTS or TECHSTREAM (TACHOMETER)

B

C

D

3.PERFORM ACTIVE TEST USING GTS or TECHSTREAM (TACHOMETER)
a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Meter / Active Test.


e.

Check the operation by referring to the table below.

Body Electrical > Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Tachometer Tachometer 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 -

OK:

Tachometer indication is normal.



Result:
Result Proceed to
OK (for 1NR-VE). A
OK (for 2NR-VE). B
NG C



A

B

C

REPLACE COMBINATION METER ASSEMBLY