Home › Drivetrain › P610 (HYBRID TRANSMISSION / TRANSAXLE) › TRANSMISSION CONTROL CABLE › 2016.10–2019.09
RM32K0E _52 Drivetrain _059722 P610 HYBRID TRANSMISSION / TRANSAXLE _0298366 TRANSMISSION CONTROL CABLE A

P610 HYBRID TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  INSTALLATION  


PROCEDURE

Hide 33820B 1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C365142

Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.
C365141

Engage the guide to connect the transmission control cable assembly to vehicle body.


c.

Install the nut.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


d.
C366448

Install the transmission control cable assembly from the cylinder head cover sub-assembly with the bolt.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


e.

Engage the clamp to connect the transmission control cable assembly.


f.
C365186N02
2.677,0.052 2.833,0.25 0.156,0.198 10 false N 3,0.698 3.156,0.896 0.156,0.198 10 false P

Turn the control shaft lever clockwise until it stops, and then from that position turn it counterclockwise by 2 notches to set it to the N position.


g.

Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.


h.

Connect the transmission control cable assembly to the control shaft lever with the nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


i.
C366437C01
0,0 0,0 false
V113147

Install in this Direction


Connect the transmission control cable assembly to the floor shift shift lever assembly.

NOTICE:

Make sure that the transmission control cable assembly is securely locked.



j.
C366436C01
0,0 0,0 false
V113147

Install in this Direction


Connect the end of the transmission control cable assembly to the floor shift shift lever assembly.

NOTICE:
·

Before connecting the transmission control cable assembly, check that the park/neutral position switch and shift lever are in neutral.

·

Install the end of the transmission control cable assembly so that the lock piece faces the driver side.

·

Install the end of the transmission control cable assembly all the way to the base of the pin.




Hide 58151 3.INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

a.

Install the front No. 1 floor heat insulator to the vehicle body with the 3 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 17410 4.INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Hide 57533B 5.INSTALL FRONT FLOOR CENTER BRACE

Hide 6.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 33504F 7.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 10.INSPECT FOR EXHAUST GAS LEAK

Hide 51444A 11.INSTALL REAR ENGINE UNDER COVER LH

Hide 51441 12.INSTALL NO. 1 ENGINE UNDER COVER